home *** CD-ROM | disk | FTP | other *** search
- NEC P9000 (TR5E800-9A)
-
- NOTES: These are single or dual NAM units
- The ESN prefix is 135 decimal, 87 hex.
- NEC: 1-800-421-2141
-
- 1. This phone officially requires an NEC programing adaptor battery
- part number 41-2010, if you have one attach it and power up the
- phone.
-
- I you do not have the NEC adaptor one can be simulated by using a standard
- battery or cigarette lighter adaptor. Remove the battery from the phone
- and locate the small black round contacts in the battery compartment.
- The right hand contact must be grounded while powering up the phone.
- To do this use a long piece of solder wick, or other thin conductive
- material, lay it over the contact and carefully replace the battery.
- Then ground the solder wick to the antenna connector or - battery contact
- and power up the phone.
-
- If you have a cigarette lighter adaptor you can disassemble it and,
- by careful measurement, drill a hole to give you easier access to the
- test mode contact.
-
- 2. Having powered up the phone using one of the above methods press
- RCL # 0 1 to enter test mode.
-
- 3. (Dual NAM units only) Press RCL # 7 6 0 for NAM 1, or RCL # 7 6 1 for
- NAM 2.
-
- 4. Press RCL # 7 1 to enter programing mode.
-
- 5. The # key stores and increments each step.
-
- 6. At any time press and hold CLR to exit programing mode then press RCL
- # 0 2 to exit test mode.
-
- PROGRAMING DATA
-
- STEP# #OF DIGITS/RANGE DESCRIPTION
-
- 01 10 DIGITS MIN (AREA CODE & TEL#)
- 02 4 DIGITS LOCK CODE
- 03 00000 - 32767 SYSTEM ID
- 04 2 DIGITS GROUP ID (10 IN USA)
- 05 333 OR 334 INITIAL PAGING CHANNEL
- 06 0 OR 1 PREFERRED SYSTEM
- 07 2 DIGITS ACCESS OVERLOAD CLASS
- 08 0 OR 1 MIN MARK
-
-
- NOTE: To toggle between NAM 1 and 2 press FCN STO 3 with phone out of
- programing mode.
-
- LOCK: F * four digits = Partial lock, F # four digits = Full lock. Use same
- sequence to unlock.
-
- SYSTEM SELECT: F 5 then 5 to scroll.